Quote by bazmod:
it may be that the proxy isn't lined up properly - have you reset x-form on both the proxy and the mesh?
Try putting p_draw_helpers 1 into the console - this will allow you to see your collision mesh in the engine and you should be able to troubleshoot the problem from there
Thanks for the reply. It seems as if none of my adjustments to the proxy have transferred over to the engine. On cryengine the proxy's are just large boxes. Also I did not reset the x-forms, The tuts I was following didn't say anything about that.
I'll give it a shot and see what happens.
Edit: Thank you, I managed to fix my bridge.